Dustproof Measures of Straightening Machine

1, Straightening machine in the use of straightening block check before, there is no straightening block fixed, or to avoid starting the machine straightening block to hurt the operator.

2, In order to cope with the process of straightening steel bars, the generated iron chips flying up, pollution of the environment, to have the relevant dust control measures.

3, After understanding the diameter of the bar to be straightened, the straightening block, rotation speed, traction wheel groove and other operations should be appropriate to the diameter of the bar, the diameter of the straightening block of the general straightening machine should be greater than the diameter of the bar 2.5 mm.

4, In order to avoid the straightening of the rebar will pop out and hurt people, we need a steel pipe first installed in the guide barrel part of the machine, used to be straightened machine rebar from the steel pipe into the guide barrel of the machine to reach the machine straightening barrel.

5, In order to make the straightening machine run smoothly, the machine should be installed on a horizontal and solid ground.

6, After the bent steel bar is loaded into the machine, the straightening machine‘s traction wheel and the operator‘s hand should have a certain distance, otherwise it will hurt the operator‘s hand.

7, The load-bearing frame in the installation needs to be operated in accordance with the prescribed method, aligning the centerline orientation of the guide cylinder, the lower cutter hole, straightening cylinder, etc.

8, Straightening machine in the end of the installation, before use to check and test all kinds of, such as: hammer, cutting gear, cylinder bearings, cutting knife and other important parts of normal, such as no other abnormal appear and clarify the machine is able to normal use.