Steps For Using the Straightening Machine Before and After Operation

The adjustment method of the metal straightening machine.

First, we need to know that we cannot prevent items on the KINGREAL Machinery metal straightening machine machinery to avoid objects falling into the body because of vibration.

Second, if the straightening block is not fixed or shield cover, we cannot be fed, and cannot open the shield and so on during the operation.

Third, after we send the rebar to the impeller to maintain the corresponding distance, not reliable too close.

Fourth, when straightening the end of the rebar, our operators must dodge to prevent flinging and injury.

Fifth, if the length of the rebar is less than 2 meters or the diameter is more than 9 mm, then we have to use low speed to carry out the operation.

Sixth, after completing the operation, we have to straighten the block back to the original position.

Seven, in the metal straightening machine to check when we can use the hand to turn the flywheel, in the gap adjustment, wait until everything is normal after we look at the bearing inside there is no sound, if all normal then we can be in the operation.

Before the operation

1) Check the straightening machine and electrical switch, the grounding of the equipment is intact.

2) Check the processing parts, pressure pad, top pad, support pad for cracks.

3) Wear and use the required labor protective equipment.

The operation

1)   Adjust the pressurization speed according to the material properties of the processed parts and the processing curvature to avoid the workpiece from fracturing and flying out.

2)   Straightening machine operators licensed to work, work in the spirit of concentration to listen to the instructions of the foreman, and pay attention to the surrounding obstacles.

3)   When working with more than one person to have command, processing parts into, back out of the turn when the foreman to give instructions to other personnel with close action consistent. Hands are not allowed to be placed between the roller and the machined parts in and out of the material frame.

4)   According to the processing of the curvature of the processed parts need to move the top pad, the contact between the top pad and the top head is not less than two-thirds. The beginning and end of the straightening machine processing parts and support pad contact should be greater than the support pad outside the central axis. In the bending of the system curvature of the larger profile, the end is not allowed to stand at the end.

5)   Processed objects in the upper and lower shelves should be directed by personnel, and only when you hear the command to start the wind top switch.

6)   The processed objects are neatly placed according to the requirements of the placement management, pad flat and put firmly.

After operation

1)   Cut off the power supply, the control system to restore the original state.

2)   Straighteners clean up and clean up the work site, do a good job of straightening machine maintenance.