CTL Machine Use Precautions and Maintenance Methods
First, shearing machine in the use of the process should pay attention to matters.
1. Start the shearing machine for a number of idle cycles to ensure that under normal circumstances, try to cut different thicknesses of plate material, from thin to thick. Ensure that the user is familiar with the performance of the shearing machine.
2. Trial shear different plate thickness must be adjusted to different blade clearance. If not adjusted to the corresponding blade clearance, it affects the durability of the blade.
3. shear in the shearing process to open the pressure gauge switch, observe the oil pressure value, cut 12mm plate pressure should be less than 20MPa. this remote regulator No9, the factory pressure adjustment 20-22MPa, the user must comply with this provision, do not cut the ultra-material surface to increase the pressure, resulting in machine damage.
4. Sound balance during operation. Shearing machine such as noise, should stop to check.
5. Shearing machine operation when the oil tank to raise the temperature < 60 degrees over when the machine is shut down to rest
Second, the shearing machine maintenance methods.
1. Strictly in accordance with the operating procedures for operation.
2, each time before starting the machine according to the requirements of the lubrication chart at regular intervals, fixed points, quantitative plus lubricating oil, oil should be clean without precipitation.
3, the machine must often keep clean, unpainted part of the anti-rust grease.
4, the motor bearings within the lubricating oil should be regularly replaced and refilled, and often check whether the electrical parts work properly and safely.
5, regularly check the v-belt, handle, knob, button is damaged, serious wear and tear should be replaced in a timely manner, and report spare parts to supplement.
6、Regularly check and repair the switch, insurance, handle, to ensure that it works reliably.
7, 10 minutes before the end of each day, the machine oil lubrication and scrubbing clean machine tools.
8, non-specified personnel are strictly prohibited from operating the equipment, usually must be done away from the machine stop.
.jpg)
Hydraulic pendulum shear due to the circular motion, and the arc blade production and quite difficult, generally with the blade after the pad iron compensation, so the resulting gap is not, cut out of the plate material is not ideal, because it is an arc movement, its blade can not be made rectangular, but should be made into an acute angle, so the force of the blade is not ideal, the blade damage is also more powerful.
+86-137 0285 5825 
sales@kingreal.org
jet-clima