It can be used with ordinary punches and pneumatic precision punches for low-speed punching and feeding, and it can also be used with high-speed punches for high-speed punching occasions.

Feeding roller surface with hardness HRC60, hard chrome plated or sand blast for non-slip, high wear resistance, can hold on machine life, improve quality and production efficiency, reduce costs. The adoption of high rigidity linear slide guide and precision ball screw can improve stability.

 Equipment  Characteristics : 
                                                                                                   
1. One-way bearing
Embedded with super hard alloy and matched with roller bearings, it has abrasion resistance, safety, high precision and long life. The gear is heat-treated H600 and then precision ground, high transmission accuracy.

2. Roller
It adopts hollow type, light weight, small rotation inertia, and can stop immediately to ensure feeding accuracy. After heat treatment, HR600 is plated hard and then ground, with high hardness, large wear resistance and long life.

3. Disc brake (general brake device)
The use of advanced clutch to make the two sides of the plate completely contact, long life, good stability and high precision.

4. Reverse device
(1) The structure is the same as the one-way device, which can control the lower wheel quite accurately, and will not cause the lower wheel to retreat even if it is used for a long time. The stability and accuracy are quite high.
(2) The brake failure does not cause the lower wheel to reverse and the feed distance is inaccurate due to the splashing of oil during stamping.
(3) It is not easy to produce high heat.
(4) With super hard alloy and rollers, it is not easy to wear.
(5) The action mode is the circular motion of the rollers, not the linear motion of 4 guide posts. There will be no biting.
(6) The friction is small, the required transmission torque is relatively reduced, and the transmission mechanism is less likely to be damaged.
(7) The speed can be 30/m/min if there is a reverse installation, generally 20m/min, which increases the efficiency by 50%.
(8) The special structure increases the service life.


 Equipment  Advantages :                                                                                                         

1. Productivity: The high-speed roller feeder is currently a widely used feeder in the stamping industry. It is easy to operate and can be processed continuously in multiple projects.

2. High speed: The number of revolutions is proportional to the length of the feed, up to 600 times per minute.

3. Strong compatibility: Regardless of the width and thickness of the material, just adjust the feeder to match the mold, which is economical and practical.

4. Energy-saving: It does not require electricity or gas source, it is connected with the output shaft of the punch, and is driven by the punch, which saves energy. Low failure rate and easy maintenance.

5. High precision: The feeding accuracy is ±0.05mm, if the guide pin is positioned, the accuracy of ±0.01mm can be obtained.

6. Safety: Adjust the telescopic adjustable pull rod to the standard length, and match the standard transmission angle with the rocker arm, which is safe and easy to use.

7. Environmental protection: The machine is quiet during operation and does not cause noise in the workplace.


 Type :                                                                                                                                       

Single type: suitable for coil material (thickness above 0.15mm), single product or continuous punching product.

Duplex: suitable for roll materials (thickness less than 0.15mm), short-length materials, single products or continuous punching products.

 About Us:

KINGREAL Machinery is a professional manufacturer and supplier. We offer full solutions in coil processing and machine tool building, which including high speed coil slitting line, copper slitting machine, 200m/min coil slitting machine, simple slitting machine, cut to length line machine, fly shearing for cut to length machine, coil ctl machine.

We have a professional team and rich project experience, can provide you with the best service, welcome to contact us.