Automatic Feeding Machine Common Faults and Handling Methods

Automatic feeding machine common failures and handling methods are as follows.

Automatic feeding machine cause analysis.
1: Insufficient pressure of feeding wheel.
2: Feeding length is too long.
3: Insufficient feeding material.
4: There are gross or objects generated in the mold.

Automatic feeding machine solutions.
1: Increase the pressure.
2: pulling material caused by poor upper mold release.
3: Check whether the width of the roll material and the position of the mold guide plate is appropriate, or whether the mold and NC are in a straight line.
4: Check if there are burrs and foreign objects on the stopper and stripper plate.

Precautions before punching and feeding machine work

(1) Check the lubrication of each part, so that each lubrication electric gets sufficient lubrication
(2) Check whether the die installation is correct and reliable.
(3) Check whether the compressed air pressure is within the specified range
(4) Check whether the switch buttons are sensitive and reliable, and be sure to disengage the flywheel and clutch before turning on the motor.
(5) Make the press make several empty strokes to check the working condition of the brake, clutch and operating part
(6) Check the main motor for abnormal heat, abnormal vibration, abnormal sound, etc.
(7) Use manual oil pump to add lithium ester oil to the ram
(8) Check and adjust the feeder roller clearance to the process requirements
(9) Check and keep the oil volume of oil misters to meet the specified requirements
(10) When the motor is on, check whether the flywheel rotation direction is the same as the rotation mark.

Automatic feeding machine automatic mode: This mode is mainly used to select the automatic feeding machine automatic operation mode, in the automatic mode can be automatic feeding machine automatic operation, while the automatic status light is on, in the selection of manual operation mode automatically exit the automatic operation mode.

Manual mode: This mode is mainly used to select the manual operation of the automatic feeder, in the manual mode can be a variety of manual operation of the automatic feeder, while the manual status light is on, in the selection of automatic operation mode automatically exit manual operation mode

Fault reset: When the automatic feeder machine alarm, and the alarm fault has been removed, it is necessary to operate this button, reset the alarm, before normal operation.

Alarm buzzer: When the material is used up, the machine failure when the buzzer will sound the alarm, is to remind the operator to use the automatic feeder needs to replenish the material or check the repair feeder.

OK indicator: the indicator used to show the working status of the feeder, when the feeder automatically starts, the OK light is on.

Continuous Stop Button: When the machine is in automatic start operation, operate this button to stop the machine from automatic operation.